Stainless Steel Drawer Magnets

Drawer Filters install at the throat openings of your machines to trap ferrous contaminants and protect your equipment and the purity of your products.

Hamilton Drawer Magnets now have greater surface holding force. That means more complete removal of contaminants and less chance of "wipe-off."

Easy to Clean - Easy to Monitor
Clear 3/8" polycarbonate drawer front lets you monitor resin flow and tramp iron accumulation at a glance. When you're ready to clean the magnetic cartridges, just shut the Slide Gate, allow the housing to empty, and remove the drawer module. Our drawer openings also give you plenty of clearance. So the chance of an accidental wipe-off as you remove the drawer is virtually eliminated.

Stainless Steel Construction
Our housings are built to last and guaranteed against defects in materials and workmanship for as long as they are owned and used by the original purchaser.

Standard housings are made from 11-gauge stainless steel. These housings are ideal for sanitary service, or corrosive environments.

All models have extra reinforcement around slide gates and drawers for superior strength and torsional rigidity in comparison to cast housings. Our drawer magnets are designed using a 5-to-1 safety factor and can support symmetrical compression loads of 10,000 pounds. Our sheet steel construction offers a far smoother interior surface than cast housings. Most powdered colorants and resins slide off without sticking. Your operators will find it much easier to purge and clean .